N63TU Inlets with Adapters for Custom Intakes

$180.00

Inlet kit for fitting forward-facing 3 inch custom intakes on an N63TU2 engine

SKU: N/A Category:

Description

Inlet kit for fitting forward-facing custom intakes on an N63TU engine.  Includes inlets, high flow turbo inlet gaskets, adapters to neck down to 3″, 3.25″, or 3.5″ tubing (inlet end is 3.5″), and inlet-to-adapter tension clamps.  Stock PCV system attaches directly to inlets with no modification required.  Adapters are designed to attach to customer provided intakes using customer supplied silicone or similar flexible couplers and hose clamps (do not use t-clamps – they provide too much clamping force for the plastic intakes)

This product is not covered by warranty since custom intake installations can result in product failure if clamped overly tight or the custom intakes add excess stress/weight to the adapters/inlets.  When installed the inlets should have slack to move as the engine moves on the engine mounts and clamps should not be overly tight.

Installation instructions:

  • Pull charge pipes off turbos (leave the intercooler ends connected)
  • Remove stock turbo inlets
  • Attach inlets to the turbos, optionally secure with the provides 6mm screws
  • Grease PCV ports on the inlets and attach PCV hoses
  • If the adapters are not already installed on the inlets:
    • Grease inside of inlet ends where the adapters with their O-rings will be inserted
    • Attach adapters to the inlets with the tension clamps (squeeze until they snap closed)
    • Attach custom intakes using hose clamps or similar

To remove tension clamps, pry open with a flathead screwdriver in the slot where the two ends of the clamp meet.

 

Additional information

Adapter Size

3.0 inch, 3.25 inch, 3.5 inch